Key this keyboard layout out. Must be similar to the Tri Chromatic Vibraphone
I see a mic above the vibes, but that's not doing anything, right?
So I read that this was an accordian layout.
Who knows about this?
Here is a dampening master in the works!
Here is another low cost idea turned into reality by applying the new possibilities of 3D printing. My next frame will be equipped with these bar posts.
My collected ideas around the vibraphone can be found here:
http://wyndorps.de/E_index.htm
LIVE ON ZOOM! THIS SUNDAY!
www.bit.ly/coffeehouse2
|
|
Due to the Corona problem, I can't get any thin-walled aluminum tube at the moment. Therefore, I have pimped my old and very much used PVC resonance tubes with a new type of flap.
The new flaps are printed from flexible plastic with a hole "too small" by about 0.1 to 0.2 mm. Therefore, they adhere very well to the shaft after sliding on, but can be aligned and positioned as desired.
I also managed to make this solution foldable. Due to the magnetic coupling, the shafts reconnect by themselves after splitting.